Design a logic circuit that converts a four digit binary input (from equivalent decimal value 0 to value 9 only) to equivalent digital display. The display is shown in the diagram given below:
You may please note that the display consists of 7 segments (all of them are visible true in display of digit 8). Thus, task for you may be to name the 7 output segments (may be s0, s1, …s6) and create the truth table for the suitable input for these segments. You need to put a value 1 (True) only for those segments that from the decimal digit. For example, to display 1 only the right most two segments should be made true. Please also note that while creating the truth table you need to use the do not care condition for input values from 1010 to 1111. After creating the truth table design the Boolean expressions for each of the seven output segments. Draw the resulting circuit diagram using AND – OR – NOT gates.
30 Nov 2017
Answer :
Word Count : 732
To design a logic circuit for converting a four-digit binary input (representing decimal values 0 to 9) to a 7-segment display, we need to determine the outputs for each of the 7 segments (s0 to s6) for each decimal digit.
Step 1: Naming the Output Segments
For a 7-segment display, the seven segments are typically named as follows:
s0: Top segment
s1: Upper-left segment
s2: Upper-right segment
s3: Middle segment
s4: Lower-left segment
s5: Lower-right segment
s6: Bottom segment
Step 2: Truth Table for 7-Segment Display
Let's create the truth table for the inputs (binary values representing digits 0 to 9) and the corresponding outputs for the 7 segments. The inputs will be in 4-bit binary form (b3, b2, b1, b0), where b3 is the most significant bit and b0 is the least significant bit.
For simplicity, we will use "don't care" conditions (denoted by X) for input values 1010 to 1111, which correspond to decimal values 10-15, as they are not used for displaying digits.